ABB IRC5 Product Manual page 226

4 Repair
4.7 Replacement of computer unit
Continued
6
Refitting
The procedure below describes how to refit the computer unit.
1
2
Continues on next page
226
Action
Support the computer unit beneath by hand
and pull the computer unit in the arrow direc-
tion.
Note
After replacing the main computer, the RobotWare system can be reset. It is then
necessary to restore a backup. For information on how to restore a backup see
Operating manual - IRC5 with FlexPendant.
Action
DANGER
Before commencing any work inside the
cabinet, please observe the safety informa-
tion in section Make sure that the main power
has been switched off on page
WARNING
The unit is sensitive to ESD. Before handling
the unit please read the safety information
in the section The unit is sensitive to ESD
on page 34
© Copyright 2004-2018 ABB. All rights reserved.
Note/illustration
xx1300000682
WARNING
Prevent the computer unit from falling
down due to gravity by supporting the
computer unit from beneath by hand.
Note/illustration
26.
Product manual - IRC5
3HAC047136-001 Revision: M