Table of Contents
Advertisement
B.2 PROM Programming Tools
B.2.1 Hardware
PG-1500
PROM programmer
PA-78P014CW
PA-78P014GC
PROM programmer adapter
B.2.2 Software
PG-1500 Controller
Remark Part number ×××× changes by the host machine or OS to be used.
µ S××××PG1500
www.DataSheet4U.com
526
APPENDIX B DEVELOPMENT TOOLS
This is a PROM programmer capable of programming the single-chip microcontroller's
on-chip PROM by manipulating from the stand-alone or host machine through connection
of a programmer adapter separately purchasable and the supplied board.
It can also program typical PROMs the capacities of which range from 256 Kbits to
4 Mbits.
This PROM programmer adapter is for the µ PD78P014 and 78P014Y and is connected
to the PG-1500.
PA-78P014CW: 64-pin plastic shrink DIP (CW type)
PA-78P014GC: 64-pin plastic QFP (GC-AB8 type)
The PG-1500 is controlled from the host machine through connection with the host
machine and PG-1500 via serial and/or parallel interface(s).
Part number: µ SxxxxPG1500
××××
Host Machine
5A13
PC-9800 series
5A10
7B13
IBM PC/AT and
7B10
compatible machine
Note MS-DOS Ver. 5.0 or later have a task swap function, but this task swap
function cannot be used in the above software.
Operating System
Supply Medium
MS-DOS
3.5-inch 2HD
Ver.3.30 to
5-inch 2HD
Note
Ver.6.2
See B.4
3.5-inch 2HD
5-inch 2HC
Advertisement
Table of Contents
