4.2.13 XT1 and XT2
Crystal resonator connection pins for subsystem clock oscillation.
For external clock supply, input it to XT1 and its inverted signal to XT2.
4.2.14 V
Positive power supply pin
4.2.15 V
Ground potential pin
4.2.16 V
High-voltage apply pin for PROM programming mode setting and program write/verify. Connect directly to V
in normal operating mode.
4.2.17 IC (Mask ROM versions only)
The IC (Internally Connected) pin sets a test mode in which the µ PD78011BY, 78012BY, 78013Y and 78014Y
are tested before shipment. In normal operation mode, connect the IC pin directly to V
as possible.
If there is a potential difference between the IC and V
pin is too long, or external noise is superimposed on the IC pin, your program may not run correctly.
www.DataSheet4U.com
CHAPTER 4 PIN FUNCTION ( µ PD78014Y Subseries)
DD
SS
( µ PD78P014Y only)
PP
• Directly connect the IC pin to the V
pins because the wiring length between the IC and V
SS
SS
V
IC
SS
shorten
with as short a wiring length
SS
.
SS
SS
89