Cyclic Signature Generation With Every Incoming Frame, Limiting Read Accesses; Limitation Of Cyclic Signature Generation - Fujitsu MB86R02 Jade-D Hardware Manual

Graphics controller

Hide thumbs Also See for MB86R02 Jade-D:

Table of Contents

MB86R02 'Jade-D' Hardware Manual V1.64

Cyclic Signature Generation with every incoming frame,

limiting read accesses

Cyclic for one window, with interrupt monitoring

General Configuration phase: (not shadowed registers)

Enable mask mode

Write mask window coordinates

Enable Signatures types

Enable interrupts

Configuration phase for calculation 0

Write Window 0 coordinates

Write reference values for Signature A

(Write reference values for Signature B, Set threshold for B)

Setup cyclic TriggerMode

Trigger cyclic generation by writing '1' to the trigger field

Wait on interrupt or poll IStsDiff

Read result registers Signature A, (B)

Process results

Before display content of evaluation window changes:

Cancel cyclic trigger and reprogram reference values

It is not recommended to change evaluation window coordinates and relating reference values during

cyclic (= continuous) monitoring mode. Reference value registers are overtaken with every frame start.

Coordinate registers are overtaken only after write of Register TriggerW0.Trigger. If nevertheless

cyclic mode is used the following real time requirement exists for the configuration of coordinate and

reference registers: The update of coordinate and reference registers must be finished within one

video frame.