Viewing A List Of Remote Server Selectors; Adding A Remote Server Selector - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 3.9.7.1

Viewing a List of Remote Server Selectors

To view a list of remote server selectors, type:
show running-config admin logging server address selector
Where:
• address is the IP address of the remote server.
If remote server selectors have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin logging server 172.30.144.254 selector
admin
logging
server 172.30.144.254
selector 1
no negate
facility-list [ all ]
!
!
!
!
If no remote server selectors have been configured, add selectors as needed. For more information, refer to
Section 3.9.7.2, "Adding a Remote Server
Section 3.9.7.2

Adding a Remote Server Selector

To add a remote server selector, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the remote server selector by typing:
admin logging server address selector name
Where:
• address is the IP address of the remote server
• name is the name of the log selector identifier
3. Configure the following parameter(s) as required:
Parameter
negate
Viewing a List of Remote Server Selectors
Selector".
Description
Synopsis: typeless
Excludes messages defined in the <emphasis>Remote
Server Selector</emphasis> fields from the log. Selecting
this option acts as a logical NOT for the selector definition.
For example: Selecting <emphasis role="bold">same</
emphasis>, <emphasis role="bold">debug</emphasis>,
and <emphasis role="bold">mail</emphasis> in the
<emphasis>Comparison</emphasis>, <emphasis>Level</
emphasis>, and <emphasis>Facility-list</emphasis> fields
includes debug messages from the mail subsystem in the
log. Selecting <emphasis role="bold">Negate</emphasis>
<emphasis>excludes</emphasis> debug messages from the mail
subsystem from the log.
Chapter 3
Device Management
69