Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Setup and Configuration
This chapter describes how to setup and configure the device for use on a network using the various features
available in RUGGEDCOM ROX II. It describes the following tasks:
•
Section 5.1, "Configuring a Basic Network"
•
Section 5.2, "Configuring ICMP Control"
•
Section 5.3, "Enabling and Configuring CLI Sessions"
•
Section 5.4, "Enabling and Configuring SFTP Sessions"
•
Section 5.5, "Enabling and Configuring WWW Interface Sessions"
•
Section 5.6, "Enabling/Disabling Brute Force Attack Protection"
•
Section 5.7, "Viewing the Status of IPv4 Routes"
•
Section 5.8, "Viewing the Status of IPv6 Routes"
•
Section 5.9, "Viewing the Memory Statistics"
•
Section 5.10, "Managing NETCONF"
•
Section 5.11, "Managing SNMP"
•
Section 5.12, "Managing Time Synchronization Functions"
•
Section 5.13, "Managing Cellular Modem Profiles"
•
Section 5.14, "Managing the DHCP Relay Agent"
•
Section 5.15, "Managing the DHCP Server"
•
Section 5.16, "Managing Port Mirroring"
•
Section 5.17, "Managing Firewalls"
•
Section 5.18, "Managing IS-IS"
•
Section 5.19, "Managing BGP"
•
Section 5.20, "Managing RIP"
•
Section 5.21, "Managing OSPF"
•
Section 5.22, "Managing Virtual Routing and Forwarding (VRF)"
•
Section 5.23, "Managing Static Routing"
•
Section 5.24, "Managing Static Multicast Routing"
•
Section 5.25, "Managing Dynamic Multicast Routing"
•
Section 5.26, "Managing Multicast Filtering"
•
Section 5.27, "Managing VRRP"
•
Section 5.28, "Managing Link Failover Protection"
•
Section 5.29, "Managing IPsec Tunnels"
•
Section 5.30, "Managing 6in4 and 4in6 Tunnels"
•
Section 5.31, "Managing Layer 2 Tunnels"
•
Section 5.32, "Managing Generic Routing Encapsulation Tunnels"
Chapter 5
Setup and Configuration
191
Advertisement
Table of Contents
Troubleshooting
