Adding A Link Failover Parameter - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
show running-config services link-failover
If parameters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services link-failover
services
link-failover switch.0001
enabled
backup fe-1-1
transfer-default-route
backup-gateway
!
backup te1-2-1c01ppp
priority
transfer-default-route
!
target 10.10.10.10
!
!
!
If no parameters have been configured, add parameters as needed. For more information, refer to
Section 5.28.3.2, "Adding a Link Failover
Section 5.28.3.2

Adding a Link Failover Parameter

To add a link failover parameter, do the following:
NOTE
The link failover feature can only be configured on a routable interface. For the link failover feature to
be used on a switched port, another VLAN must be configured (for example, switch.0002) to logically
differentiate the switched port from the default PVID VLAN 1 (switch.0001).
1. Make sure the CLI is in Configuration mode.
2. Add the parameter by typing:
services link-failover interface
Where:
• interface is the name of the interface
3. Configure the following parameter(s) as required:
Parameter
enabled
ping-timeout { ping-timeout }
ping-interval { ping-interval }
ping-retry { ping-retry }
450
192.168.1.2
second
Parameter".
Description
Synopsis: typeless
Enables this link backup.
Synopsis: An integer between 1 and 65536
Default: 2
The time interval, in seconds, before immediately retrying a ping.
Synopsis: An integer between 0 and 65536
Default: 60
The time interval, in seconds, between ping tests.
Synopsis: An integer between 0 and 65536
Default: 3
Adding a Link Failover Parameter
RUGGEDCOM ROX II
CLI User Guide