RUGGEDCOM ROX II
CLI User Guide
Section 5.27.6.3
Deleting a VRRP Instance
To delete a VRRP instance, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the instance by typing:
no services vrrp instance name
Where:
• name is the name of the VRRP instance
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.27.7
Managing VRRP Monitors
A VRRP monitor selects an extra interface to monitor. If the interface becomes unavailable, the router will
relinquish control of the gateway IP address to another VRRP Router.
The following sections describe how to configure and manage VRRP monitors:
•
Section 5.27.7.1, "Viewing a List of VRRP Monitors"
•
Section 5.27.7.2, "Adding a VRRP Monitor"
•
Section 5.27.7.3, "Deleting a VRRP Monitor"
Section 5.27.7.1
Viewing a List of VRRP Monitors
To view a list of VRRP monitors, type:
show running-config services vrrp instance name monitor
Where:
• name is the name of the VRRP instance
If monitors have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services vrrp instance monitor
services
vrrp
instance vid20
monitor fe-cm-1
!
!
!
!
If no VRRP monitors have been configured, add monitors as needed. For more information, refer to
Section 5.27.7.2, "Adding a VRRP
Deleting a VRRP Instance
Monitor".
Chapter 5
Setup and Configuration
443