Deleting A Dhcp Listen Interface; Managing Shared Networks; Viewing A List Of Shared Networks - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
services dhcpserver interface name
Where:
• name is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.15.5.3

Deleting a DHCP Listen Interface

To delete a DHCP listen interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the interface by typing:
no services dhcpserver interface name
Where:
• name is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.15.6

Managing Shared Networks

Shared networks are used when multiple subnets should be served by a single physical port. This applies both
when using a DHCP relay agent connected to the port with additional subnets behind the relay agent, or when
multiple virtual networks exist on one physical interface. Each subnet then gets its own subnet definition inside
the shared network rather than at the top level. Shared networks contain subnets, groups and hosts.
The following sections describe how to configure and manage shared networks on a DHCP server:
• Section 5.15.6.1, "Viewing a List of Shared Networks"
• Section 5.15.6.2, "Adding a Shared Network"
• Section 5.15.6.3, "Configuring Shared Network Options"
• Section 5.15.6.4, "Configuring a Shared Network Client"
• Section 5.15.6.5, "Customizing Shared Network Clients"
• Section 5.15.6.6, "Deleting a Shared Network"
Section 5.15.6.1

Viewing a List of Shared Networks

To view a list of shared networks, type:
show running-config services dhcpserver shared-network
If shared networks have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver shared-network
services
240
RUGGEDCOM ROX II
CLI User Guide
Deleting a DHCP Listen Interface