Viewing The Status Of The Ldp Discovery Interfaces - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Parameter
local-label
next-hop
remote-label
in-use
Section 5.41.7.2

Viewing the Status of the LDP Discovery Interfaces

To view the status of the LDP discovery interfaces on the device, type:
show mpls ldp status discovery
If LDP discovery interfaces have been configured, a table similar to the following example appears:
ruggedcom# show mpls ldp status discovery
status discovery
local id 4.4.4.4
interfaces
INTERFACE SRC IP ADDR
---------------------------------------------------------
switch.0010 192.168.10.2
switch.0020 192.168.20.1
This table provides the following information:
Parameter
interface
src-ip-addr
peer-id
peer-ip
state
For more information about configuring LDP discovery interfaces, refer to
an LDP Interface".
608
PEER ID PEER IP
2.2.2.2 192.168.10.1
6.6.6.6 192.168.20.2
Description
Synopsis: A string
The incoming (local) label.
Synopsis: A string
The destination next hop router.
Synopsis: A string
The LDP remote label.
Synopsis: A string
The LDP in-use flag.
STATE
OPER
OPER
Description
Synopsis: A string
The LDP discovery interface.
Synopsis: A string
The LDP discovery source IP address.
Synopsis: A string
The LDP discovery peer ID.
Synopsis: A string
LDP discovery peer IP address
Synopsis: A string
The LDP discovery interface state.
Section 5.41.7.9, "Enabling/Disabling
Viewing the Status of the LDP Discovery Interfaces
RUGGEDCOM ROX II
CLI User Guide