Adding A Prefix List; Adding A Prefix Entry - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.20.3.3

Adding a Prefix List

To add a prefix list for dynamic RIP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the list by typing:
routing rip filter prefix-list name
Where:
• name is the name of the prefix list
3. Configure the following parameter(s) as required:
Parameter
description { description }
4. Add prefix entries as needed. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.20.3.4

Adding a Prefix Entry

To add an entry for a dynamic RIP prefix list, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the entry by typing:
routing rip filter prefix-list name entry number
Where:
• name is the name of the prefix list
• number is the sequence number for the entry
3. Configure the following parameter(s) as required:
Parameter
action { action }
subnet { subnet }
le { le }
ge { ge }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Adding a Prefix List
Description
Synopsis: A string 1 to 1024 characters long
The description of the prefix list.
Section 5.20.3.4, "Adding a Prefix
Description
Synopsis: { deny, permit }
Default: permit
The action that will be performed.
Synopsis: A string 9 to 18 characters long
The IPv4 network address and prefix.
Synopsis: An integer between 1 and 32
The maximum prefix length to be matched.
Synopsis: An integer between 1 and 32
The minimum prefix length to be matched.
Chapter 5
Setup and Configuration
Entry".
343