Managing Interfaces For Static Vrf Routes; Viewing A List Of Gateways For Static Vrf Routes; Adding A Gateway For A Static Vrf Route - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
• gateway is the gateway address for the static route
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.22.15

Managing Interfaces for Static VRF Routes

The following sections describe how to configure and manage interfaces for static VRF routes:
• Section 5.22.15.1, "Viewing a List of Gateways for Static VRF Routes"
• Section 5.22.15.2, "Adding a Gateway for a Static VRF Route"
• Section 5.22.15.3, "Deleting a Gateway for a Static VRF Route"
Section 5.22.15.1

Viewing a List of Gateways for Static VRF Routes

To view a list of interfaces assigned to an IPv4 static route, type:
show running-config routing vrf vrf ipv4 route dev
Where:
• vrf is the chosen VRF instance.
If gateway addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing vrf VRF1 ipv4 route dev | tab
NETWORK
--------------------------------------
192.168.10.0/24
!
If no gateway addresses have been configured, add addresses as needed. For more information, refer to
Section 5.22.15.2, "Adding a Gateway for a Static VRF
Section 5.22.15.2

Adding a Gateway for a Static VRF Route

To add an interface for an static VRF route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the gateway address by typing:
routing vrf vrf ipv4 route subnet dev interface
Where:
• vrf is the chosen VRF instance.
• subnet is the subnet (network/prefix) of the static route
• interface is the name of the interface for the static route
402
INTERFACE DISTANCE
fe-cm-1 -
Route".
Managing Interfaces for Static VRF Routes
RUGGEDCOM ROX II
CLI User Guide