Enabling/Disabling Vrrp; Managing Vrrp Trackers - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
NAME STATE PRIORITY
--------------------------------------------------------------------------------
v1 master 100
This table or list provides the following information:
Parameter
name
state
priority
time-change
interface-state
Section 5.27.3

Enabling/Disabling VRRP

To enable or disable VRRP, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable VRRP by typing:
Enabling VRRP
services vrrp enabled
Disabling VRRP
no services vrrp enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.27.4

Managing VRRP Trackers

VRRP trackers monitor the state/condition of a route. When the route is unavailable, VRRP will lower its priority
or transition it to a fault state.
NOTE
The decision to increase or decrease the priority of a route must be done in coordination with any
backup VRRP Routers since the priority decides whether a router becomes a Master or a Backup. For
example, if Router X's priority is 150 and Router Y's priority is 145, Router X's priority must be lowered
by 6 to make it a Backup router.
The following sections describe how to configure and manage VRRP trackers:
• Section 5.27.4.1, "Viewing a List of VRRP Trackers"
Enabling/Disabling VRRP
TIME CHANGE
Sat Feb 2 06:30:41 EST 2013
Description
Synopsis: A string
The VRRP instance name.
Synopsis: A string
The VRRP instance state.
Synopsis: A string
The VRRP instance priority.
Synopsis: A string
The time of change to the current state.
Synopsis: A string
The VRRP interface state.
STATE STATE
fe-cm-1 is Up
Chapter 5
Setup and Configuration
437