Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Parameter
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.29.5.3
Deleting a Pre-Shared Key
To delete a pre-shared key, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the pre-shared key by typing:
no tunnel ipsec preshared-key [ remote-address | local-address ] key key
Where:
• remote-address is the remote IP address
• local-address is the local IP address
• key is the is the content of the pre-shared key
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.29.6
Managing Connections
An IPsec connection is an encrypted connection between two devices who share the same pre-authorized
authentication key.
The following sections describe how to configure and manage connections for an IPsec connection:
•
Section 5.29.6.1, "Viewing a List of Connections"
•
Section 5.29.6.2, "Adding a Connection"
•
Section 5.29.6.3, "Configuring Dead Peer Detection"
•
Section 5.29.6.4, "Deleting a Connection"
Section 5.29.6.1
Viewing a List of Connections
To view a list of connections configured for a VPN, type:
show tunnel ipsec connection
If connections have been configured, a table similar to the following example appears:
ruggedcom# show running-config tunnel ipsec connection
tunnel
ipsec
connection ipsec-12
no l2tp
ike algorithm 3des md5 modp8192
Deleting a Pre-Shared Key
Description
The pre-shared key.
Chapter 5
Setup and Configuration
463
Advertisement
Table of Contents
Troubleshooting
