Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
3.
Navigate to tunnel » l2tpv3 » static » tunnel and configure the following parameter(s) as required:
Parameter
{ tunnel-name }
enabled
tunnel-id { tunnel-id }
remote-tunnel-id { remote-tunnel-id }
transport-encap { transport-encap }
local-ip { local-ip }
local-port { local-port }
remote-ip { remote-ip }
remote-port { remote-port }
4.
Navigate to tunnel » l2tpv3 » static » tunnel » {tunnel-name} » session and configure the following
parameter(s) as required:
Parameter
{ session-name }
enabled
local-session-id { local-session-id }
remote-session-id { remote-session-id }
l2tp-specific-sublayer { l2tp-specific-
sublayer }
Configuring L2TPv3 Tunnels
Description
Synopsis: A string 1 to 3 characters long
Tunnel name, contains any lower case letter or numerical digit.
Prefix 'l2t-' will be added to tunnel name and session name to create l2tpv3 system
interface name (ie. l2tp-1-1)
Synopsis: true or false
Default: true
Enables/Disables the tunnel
Synopsis: An integer between 1 and 65535
The local tunnel-id
Synopsis: An integer between 1 and 65535
Tunnel-id of remote tunnel endpoint
Synopsis: { udp, ip }
Default: udp
The transport protocol (UDP or IP) to encapsulate the tunnel messages
Synopsis: A string 7 to 15 characters long or a string 6 to 40 characters long
Ip address of local interface
Synopsis: An integer between 1024 and 65535
Local listening transport port for tunnel service
Synopsis: A string 7 to 15 characters long or a string 6 to 40 characters long
Ip address of remote tunnel endpoint
Synopsis: An integer between 1024 and 65535
The listening transport port of remote device for tunnel service
Description
Synopsis: A string 1 to 2 characters long
Session name, contains any lower case letter or numerical digit.
Prefix 'l2t-' will be added to tunnel name and session name to create l2tpv3 system
interface name (ie. l2tp-1-1)
Synopsis: true or false
Default: true
Enables/Disables the session
Synopsis: An integer between 1 and 65535
The local session-id provides the necessary context for all further packet processing
Synopsis: An integer between 1 and 65535
The remote session-id is used to identify the received data messages from remote
session endpoint
Synopsis: { default, none }
Default: default
L2TP specific sublayer processing type
Chapter 5
Setup and Configuration
479
Advertisement
Table of Contents
Troubleshooting
