Managing Interfaces; Viewing A List Of Interfaces; Configuring An Interface - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
• name is the unique name for a routing process that belongs to a specific router.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.18.6

Managing Interfaces

IS-IS transmits hello packets and Link-State Packets (LSPs) through IS-IS enabled interfaces.
NOTE
IS-IS is only supported on Ethernet and WAN (HDLC-ETH) interfaces.
The following sections describe how to configure and manage interfaces for IS-IS:
• Section 5.18.6.1, "Viewing a List of Interfaces"
• Section 5.18.6.2, "Configuring an Interface"
Section 5.18.6.1

Viewing a List of Interfaces

To view a list of interfaces for dynamic IS-IS routes, type:
show running-config routing isis interface
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing isis interface | tab
IPV4
AREA
HELLO PSNP
IFNAME TAG
MULTIPLIER INTERVAL
-------------------------------------------------------------------------------------------------------
fe-cm-1 Area_1
10 2
switch.0001 Area_2
10 2
!
Interfaces are added automatically when a VLAN is created. For more information about creating a VLAN, refer to
Section 5.37, "Managing
Section 5.18.6.2

Configuring an Interface

When IS-IS is enabled, two interfaces are already configured: fe-cm-01 and switch.0001.
To configure optional parameters for these and any other interfaces that have been added for IS-IS, do the
following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to the interface by typing:
302
POINT
TO
CIRCUIT TYPE POINT PASSIVE
level-1-2 true true
level-1-only false true
VLANs".
CIRCUIT CIRCUIT
PASSWORD AUTHORIZATION
admin md5
admin clear
RUGGEDCOM ROX II
CLI User Guide
CSNP HELLO
METRIC INTERVAL INTERVAL
10 10 3
10 10 3
Managing Interfaces