Siemens RUGGEDCOM ROX II User Manual page 633

RUGGEDCOM ROX II
CLI User Guide
• interface is the name of the interface
3. Configure the following parameter(s) as required:
Parameter
enable-ra
adv-interval-option
home-agent-config-flag
home-agent-lifetime { home-agent-lifetime }
home-agent-preference { home-agent-preference }
managed-config-flag
other-config-flag
ra-lifetime { ra-lifetime }
reachable-time-msec { reachable-time-msec }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Configuring IPv6 Neighbor Discovery
Description
Synopsis: typeless
Enable to send router advertisement messages.
Synopsis: typeless
Includes an Advertisement Interval option which indicates to
hosts the maximum time in milliseconds, between successive
unsolicited router advertisements.
Synopsis: typeless
Sets/unsets the flag in IPv6 router advertisements which
indicates to hosts that the router acts as a home agent and
includes a home agent option.
Synopsis: An integer between 0 and 65520
Default: 1800
The value to be placed in the home agent option, when the home
agent configuration flag is set, which indicates the home agent
lifetime to hosts. A value of 0 means to place a router lifetime
value.
Synopsis: An integer between 0 and 65535
Default: 0
The value to be placed in the home agent option, when the home
agent configuration flag is set, which indicates the home agent
preference to hosts.
Synopsis: typeless
The flag in IPv6 router advertisements, which indicates to
hosts that they should use the managed (stateful) protocol
for addresses autoconfiguraiton in addition to any addresses
autoconfigured using stateless address autoconfiguration.
Synopsis: typeless
The flag in IPv6 router advertisements, which indicates to hosts
that they should use the administered (stateful) protocol to obtain
autoconfiguration information other than addresses.
Synopsis: An integer between 0 and 9000
Default: 1800
The value (in seconds) to be placed in the Router Lifetime field
of router advertisements sent from the interface. Indicates the
usefulness of the router as a default router on this interface.
Setting the value to zero indicates that the router should not be
considered a default router on this interface. It must be either
zero or between the value specified with the IPv6 nd ra-interval
(or default) and 9000 seconds.
Synopsis: An integer between 0 and 3600000
Default: 0
The value (in milliseconds) to be placed in the Reachable Time
field in the router advertisement messages sent by the router.
The configured time enables the router to detect unavailable
neighbors. The value zero means unspecified (by this router).
Chapter 5
Setup and Configuration
595