Configuring Ldp; Configuring Neighbor Discovery - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
peer-session-holdtime
Section 5.41.7.6

Configuring LDP

To configure the LDP, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable the LDP by typing the following commands:
Enable
mpls ldp enable
Disable
no mpls ldp enable
3. Configure the following parameter(s) as required:
Parameter
enabled
holdtime { holdtime }
Section 5.41.7.7

Configuring Neighbor Discovery

To configure the LDP neighbor discovery, do the following:
1. Make sure the CLI is in Configuration mode.
2. To configure the LDP Neighbor Discovery, type the following command:
mpls ldp discovery
3. Configure the following parameter(s) as required:
Parameter
interval { interval }
holdtime { holdtime }
Configuring LDP
Description
Synopsis: A string
The peer session holdtime of the LDP neighbor discovery.
Description
Synopsis: true or false
Default: false
A boolean flag to indicate that Label Distribution Protocol (LDP) is
enabled.
Prerequisite: MPLS must be enabled before enabling LDP.
Prerequisite: MPLS static bindings must be removed before
enabling LDP.
Default: 180
The session holdtime (in seconds), used as the keepalive timeout
to maintain the Label Distribution Protocol (LDP) session in the
absence of LDP messages from the session peer.
Description
Default: 5
The time (in seconds) between the sending of consecutive Hello
messages.
Default: 15
Chapter 5
Setup and Configuration
611