Viewing The Status Of Mpls Interfaces; Viewing A List Of Mpls Interfaces - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
• Section 5.41.4.1, "Viewing the Status of MPLS Interfaces"
• Section 5.41.4.2, "Viewing a List of MPLS Interfaces"
• Section 5.41.4.3, "Enabling/Disabling an MPLS Interface"
Section 5.41.4.1

Viewing the Status of MPLS Interfaces

To view the status of the MPLS interfaces on the device, type:
show mpls status interfaces
If MPLS interfaces have been enabled on the device, a table similar to the following example appears:
show mpls status interfaces
MPLS
INTERFACES STATUS
---------------------
switch.0010 yes
switch.0020 yes
This table provides the following information:
Parameter
mpls-interfaces
status
If no MPLS interface has been enabled, enable interfaces as needed. For more information about enabling MPLS
interfaces, refer to Section 5.41.4.3, "Enabling/Disabling an MPLS
Section 5.41.4.2

Viewing a List of MPLS Interfaces

To view a list of MPLS interfaces, type:
show running-config mpls interface-mpls
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config mpls interface-mpls | tab
IFNAME ENABLED
----------------------
fe-cm-1 false
switch.0001 false
switch.0010 true
switch.0020 false
!
Where:
• IFNAME is the name of the interface
Viewing the Status of MPLS Interfaces
Description
Synopsis: A string
The interface that has been enabled for MPLS.
Synopsis: A string
The operational status.
Interface".
Chapter 5
Setup and Configuration
601