Viewing A List Of Egress Marks - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.39.8.1

Viewing a List of Egress Marks

To view a list of egress marks for a QoS map, type:
• For Switched Ethernet Ports
show running-config interface switch vlans all-vlans id qosmap priority egress
Where:
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
• For Routable-Only Ethernet Ports
show running-config interface eth slot port vlan id qosmap priority egress
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
• For Virtual Switches
show running-config interface virtualswitch id vlan vlan-id qosmap priority egress
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
• For WAN Interfaces
show running-config interface wan slot port vlan id qosmap priority egress
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
If egress marks have been configured, a table or list similar to the following example appears:
show running-config interface virtualswitch vs1 vlan 100 qosmap 2 egress
interface
virtualswitch vs1
vlan 100
qosmap 2
egress 11
!
!
!
!
!
Viewing a List of Egress Marks
Chapter 5
Setup and Configuration
587