Viewing A List Of Rules Assigned To A Virtual Switch Filter; Adding A Rule - Siemens RUGGEDCOM ROX II User Manual

Chapter 3
Device Management
Section 3.24.6.2

Viewing a List of Rules Assigned to a Virtual Switch Filter

To view a list of rules assigned to a virtual switch filter, type:
show running-config security virtualswitch-filter virtualswitch name rule
Where:
• name is the name of the virtual switch filter
If rules have been assigned, a table or list similar to the following example appears:
ruggedcom# show running-config security virtualswitch-filter virtualswitch vs1 rule | tab
NAME ROUTE NAME
----------------------------------------
arp X
ipv4 X
ipv6 -
switch.0010
iso -
switch.0010
goose -
switch.0010
!
!
!
If no rules have been assigned, assign them as needed. For more information, refer to
a Rule to a Virtual Switch
Section 3.24.6.3

Adding a Rule

To add a rule that can be used by a virtual switch filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Make sure one or more virtual switches are configured. For more information, refer to
"Adding a Virtual
3. Add the virtual switch filter by typing:
security virtualswitch-filter rules rule
Where:
• rule is the name of the rule
4. Configure the following parameter(s) as required:
Parameter
action { action }
srcmac { srcmac }
152
NAME
switch.0020
switch.0020
switch.0020
Filter".
Switch".
Description
Synopsis: { accept, drop }
Default: accept
The action taken when an incoming frame meets the criteria.
Synopsis: A string
Viewing a List of Rules Assigned to a Virtual Switch Filter
RUGGEDCOM ROX II
CLI User Guide
Section 3.24.6.4, "Adding
Section 3.24.2,