Table of Contents
Advertisement
Chapter 3
Device Management
Section 3.20.7
Deleting a Serial Port Protocol
To delete a serial port protocol, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the serial port protocol by typing:
no interface serial slot port protocols protocol
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• protocol is the protocol type
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.20.8
Managing Device Address Tables
The following sections describe how to configure and manage Device Address tables:
•
Section 3.20.8.1, "Viewing a List of Device Address Tables"
•
Section 3.20.8.2, "Adding a Device Address Table"
•
Section 3.20.8.3, "Deleting a Device Address Table"
Section 3.20.8.1
Viewing a List of Device Address Tables
To view a list of Device Address tables configured for a serial port using the DNP protocol, type:
show running-config interface serial slot/port protocols dnp setdnp device-table
Where:
• slot/port is the slot name and port number of the serial port
If Device Address tables have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface serial protocols dnp setdnp device-table
interface
serial lm3 1
protocols dnp
setdnp device-table 12
remote-ip
remote-device
!
!
!
!
If no Device Address tables have been configured, add tables as needed. For more information, refer to
Section 3.20.8.2, "Adding a Device Address
118
172.30.130.2
Table".
RUGGEDCOM ROX II
CLI User Guide
Deleting a Serial Port Protocol
Advertisement
Table of Contents
Troubleshooting
