Chapter 5
Setup and Configuration
Section 5.11.5.2
Adding an SNMP Community
To add an SNMP community, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the SNMP community by typing:
admin snmp snmp-community name
Where:
• name is the name of the community
3.
Configure the following parameter(s) as required:
Parameter
{ community-name }
user-name { user-name }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.11.5.3
Deleting an SNMP Community
To delete an SNMP community, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the SNMP community by typing:
no admin snmp snmp-community name
Where:
• name is the name of the community
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.11.6
Managing SNMP Target Addresses
The following sections describe how to configure and manage SNMP target addresses:
•
Section 5.11.6.1, "Viewing a List of SNMP Target Addresses"
•
Section 5.11.6.2, "Adding an SNMP Target Address"
•
Section 5.11.6.3, "Deleting an SNMP Target Address"
208
Description
Synopsis: A string 1 to 32 characters long
The SNMP community name.
The SNMP community security name.
RUGGEDCOM ROX II
CLI User Guide
Adding an SNMP Community