Adding A Prepended Autonomous System Path Filter; Adding An Excluded Autonomous System Path Filter; Deleting A Prepended Autonomous System Path Filter - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
If no excluded autonomous system path filters have been configured, add filters as needed. For more information,
refer to Section 5.19.4.4, "Adding an Excluded Autonomous System Path
Section 5.19.4.3

Adding a Prepended Autonomous System Path Filter

To add a prepended autonomous system path filter to a BGP route map entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the path by typing:
routing bgp filter route-map name entry number set as-path prepend path
Where:
• name is the name of the route map
• number is the entry number
• path is the number for the autonomous system path
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.19.4.4

Adding an Excluded Autonomous System Path filter

To add an excluded autonomous system path filter to a BGP route map entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the path by typing:
routing bgp filter route-map name entry number set as-path exclude path
Where:
• name is the name of the route map
• number is the entry number
• path is the number for the autonomous system path
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.19.4.5

Deleting a Prepended Autonomous System Path Filter

To delete a prepended autonomous system path filter from a BGP route map entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the network by typing:
no routing bgp filter route-map name entry number set as-path prepend path
Where:
• name is the name of the route map
Adding a Prepended Autonomous System Path Filter
Setup and Configuration
filter".
Chapter 5
323