Configuring L2Tpv3 Tunnels - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Parameter
max-connection { max-connection }
closing-wait-timeout { closing-wait-
timeout }
primary { primary }
secondary { secondary }
primary { primary }
secondary { secondary }
auth-local
mtu { mtu }
mru { mru }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.31.3

Configuring L2TPv3 Tunnels

L2TPv3 improves the performance of bridging Ethernet frames over a WAN interface. Ethernet frames are
bridged over an IP network at high data packet rates and low CPU consumption. IEC61850 GOOSE messages
exchange and LAN extension are some applications of this feature.
RUGGEDCOM ROX II supports Static L2TPv3 tunnel over UDP starting with version 2.5. Static tunnel is an
unmanaged tunnel type. All tunnel information, such as tunnel id, session id, cookies etc., must be agreed in
advance between two endpoints to establish a tunnel. There are no control messages exchanged with this type of
tunnel.
To configure L2TPv3 tunnels, do the following:
1. Make sure the CLI is in Configuration mode.
Navigate to tunnel » l2tpv3 » static and configure the following parameter(s) as required:
2.
Parameter
enabled
478
Description
Synopsis: An integer between 1 and 10
The maximum number of connections.
Synopsis: An integer between 5 and 120
Default: 60
The number of seconds to wait before the tunnel is cleaned up after the tunnel moves to
closing-wait state.
Synopsis: A string 7 to 15 characters long
The primary DNS server.
Synopsis: A string 7 to 15 characters long
The secondary DNS server.
Synopsis: A string 7 to 15 characters long
The primary WINS server.
Synopsis: A string 7 to 15 characters long
The secondary WINS server.
Synopsis: typeless
Authorizes locally instead of using radius server.
Synopsis: An integer between 68 and 1500
Default: 1410
The Maximum Transmit Unit (MTU) or maximum packet size transmitted.
Synopsis: An integer between 68 and 1500
Default: 1410
The Maximum Receive Unit (MRU) or maximum packet size passed when received.
Description
Synopsis: typeless
Enables the static L2TPv3 service
RUGGEDCOM ROX II
CLI User Guide
Configuring L2TPv3 Tunnels