Setting A User Password/Passphrase - Siemens RUGGEDCOM ROX II User Manual

Chapter 4
System Administration
To configure the password/passphrase complexity rules for all passwords/passphrases, do the following:
NOTE
Password/passphrase complexity rules do not apply to passwords/passphrases previously configured
on the device.
1. Make sure the CLI is in Configuration mode.
2. Navigate to admin » authentication and configure the following parameter(s) as required:
Parameter
minimum-length { minimum-length }
maximum-length { maximum-length }
uppercase-required
lowercase-required
digits-required
special-characters-required
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 4.10.2

Setting a User Password/Passphrase

To set the password/passphrase for a user profile, type:
IMPORTANT!
Passwords/passphrases that contain special characters, including spaces, must be wrapped in quotes
(e.g. "password!2#").
admin users userid profile set-password new-password new-password-passphrase new-password-repeat new-
password-passphrase
If special characters are used, make sure to encapsulate the password in double-quotation marks (") as follows:
NOTE
RUGGEDCOM ROX II supports the following special characters in passwords/passphrases: !@#$
%^&*()_+-={}[];:',<.>/?\|`~.
182
Description
Synopsis: An integer between 1 and 128
Default: 12
Minimum password length.
Synopsis: An integer between 1 and 128
Default: 128
Maximum password length.
Synopsis: true or false
Default: true
Requires the password to have at least one uppercase letter.
Synopsis: true or false
Default: true
Requires the password to have at least one lowercase letter.
Synopsis: true or false
Default: true
Requires the password to have at least one numerical digit.
Synopsis: true or false
Default: true
Requires the password to have at least one non-alphanumeric
character. Allowed characters include "!@#$%^&*()_+-={}
[];:',<.>/?\|`~".
Setting a User Password/Passphrase
RUGGEDCOM ROX II
CLI User Guide