Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Section 2.7
Configuring the CLI Interface
The following commands can be used to configure certain characteristics and customize the CLI interface.
Parameter
autowizard { true | false }
clear history
display-level
history integer
output-file { filename | terminal }
paginate { true | false }
screen-length integer
screen-width integer
show-defaults { true | false }
terminal { dumb | vt100 | xterm | linux | ansi }
Section 2.8
Accessing Different Modes
Aside from normal mode, there are three additional modes within RUGGEDCOM ROX II that offer various
controls over the operating system.
The following sections describe how to access the different modes within RUGGEDCOM ROX II:
•
Section 2.8.1, "Accessing BIST Mode"
Configuring the CLI Interface
Description
When enabled, the CLI prompts for required settings when a new
identifier is created.
Clears the CLI history.
Determines the depth of hierarchical information to display in
command results.
Determines the number of items to record in the CLI history.
Directs CLI output to the specified ASCII text file, or to the terminal.
Output is directed to the specified destination until another
destination is set with a subsequent output-file command.
Lengthy output is paginated by default. When the output reaches the
screen-length setting, the CLI prompts the user to press a key for
more output. Press Enter to advance line-by-line or press Space to
advance page-by-page. When disabled, output is not paginated.
Determines the number of lines in a terminal page.
Determines the length of terminal lines.
Determines if default values are shown when displaying the
configuration. When enabled, default values appear as comments
after the configured value. In the following example, the default
value for the contact value is shown as a comment following the
configured contact string of wsmith@example.com:
ruggedcom# show running-config admin contact
admin
contact "wsmith@example.com"
!
Default values only appear for parameters that have default values.
If a parameter does not have a default value, no default appears
when show-defaults is set to true.
Determines the terminal type and controls how line editing is
performed. Supported terminals are: dumb, vt100, xterm, linux, and
ansi. Other terminals may also work but have no explicit support.
Chapter 2
Using RUGGEDCOM ROX II
! Contact
43
Advertisement
Table of Contents
Troubleshooting
