RUGGEDCOM ROX II
CLI User Guide
Section 5.19.9
Managing Aggregate Addresses
The following sections describe how to configure and manage aggregate addresses:
•
Section 5.19.9.1, "Viewing a List of Aggregate Addresses"
•
Section 5.19.9.2, "Adding an Aggregate Address"
•
Section 5.19.9.3, "Deleting an Aggregate Address"
Section 5.19.9.1
Viewing a List of Aggregate Addresses
To view a list of aggregate addresses for dynamic BGP routes, type:
routing bgp aggregate-address
If addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp aggregate-address
routing bgp
aggregate-address 11.11.0.0/16
options summary-only
!
!
!
If no aggregate addresses have been configured, add addresses as needed. For more information, refer to
Section 5.19.9.2, "Adding an Aggregate
Section 5.19.9.2
Adding an Aggregate Address
To add an aggregate address for dynamic BGP routes, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the path by typing:
routing bgp aggregate-address address
Where:
• address is the subnet address and prefix for the aggregate address
3.
If necessary, configure options for the address. For more information, refer to
Aggregate Address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.19.9.3
Deleting an Aggregate Address
To delete an aggregate address for dynamic BGP routes, do the following:
1.
Make sure the CLI is in Configuration mode.
Managing Aggregate Addresses
Address".
Option".
Setup and Configuration
Section 5.19.10.2, "Adding an
Chapter 5
335