Associating An Interface With A Zone - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
description { description }
Parameter
arp_filter
routeback
tcpflags
dhcp
norfc1918
routefilter
proxyarp
maclist
nosmurfs
logmartians
6. Associate the interface with a pre-defined zone or mark the associated zone as undefined. For more
information about associating the interface with a zone, refer to
with a Zone"
7. Configure a broadcast address for the interface. For more information configuring a broadcast address, refer
to Section 5.17.9.4, "Configuring a Broadcast Address"
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
8.
Section 5.17.9.3

Associating an Interface with a Zone

To associate an interface with a pre-defined zone or mark the associated zone as undefined, do the following:
Associating an Interface with a Zone
Description
Synopsis: A string
(Optional) The description string for this interface
Description
Synopsis: typeless
IPv4 ONLY. Responds only to ARP requests for configured IP
addresses (This is permanently enabled system wide since ROX
2.3.0, and this option no longer has any effect).
Synopsis: typeless
IPv4 and IPv6. Allows traffic on this interface to be routed back
out that same interface.
Synopsis: typeless
IPv4 and IPv6. Illegal combinations of TCP flags dropped and
logged at info level.
Synopsis: typeless
IPv4 and IPv6. Allows DHCP datagrams to enter and leave the
interface.
Synopsis: typeless
Not currently implemented
Synopsis: typeless
IPv4 only. Enables route filtering.
Synopsis: typeless
IPv4 ONLY. 1Enables proxy ARP.
Synopsis: typeless
IPv4 ONLY. Not currently implemented
Synopsis: typeless
IPv4 ONLY. Packets with a broadcast address as the source are
dropped and logged at info level.
Synopsis: typeless
IPv4 ONLY. Enables logging of packets with impossible source
addresses.
Section 5.17.9.3, "Associating an Interface
Chapter 5
Setup and Configuration
279