Viewing A List Of Pim-Sm Interfaces - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
default-preference { default-preference }
default-metric { default-metric }
broken-cisco-checksum
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.25.3

Viewing a List of PIM-SM Interfaces

1. Make sure the CLI is in Configuration mode.
Navigate to routing » multicast » dynamic » pim-sm and press Enter.
2.
At the command prompt, type show full-configuration and press Enter.The PIM-SM interfaces
3.
information appears:
ruggedcom(config-pim-sm)# show full-configuration | tab
routing multicast dynamic pim-sm
enabled
bsr-candidate local-address 1.1.1.1
bsr-candidate priority 1
rp-candidate local-address 1.1.1.1
rp-candidate priority 1
no broken-cisco-checksum
interface
IFNAME
----------------------
dummy0
fe-1-1
fe-1-16
fe-cm-1
ge-sm-1
switch.0001
group-prefix
PREFIX
--------------
225.0.0.1/32
225.0.0.2/32
!
If no PIM-SM interfaces have been configured, enable interfaces as needed. For more information about enabling
PIM-SM interfaces, refer to
Viewing a List of PIM-SM Interfaces
PASSIVE
false
false
false
true
false
true
Section 5.25.4, "Enabling/Disabling a PIM-SM
Description
Synopsis: An integer
Default: 1024
Default preference value. Preferences are used by assert
elections to determine upstream routers.
Synopsis: An integer
Default: 1024
Default metric value. Metric is the cost of sending data through
interface.
Synopsis: typeless
If your RP is a cisco and shows many PIM_REGISTER
checksum errors from this router, setting this option will help.
Interface".
Chapter 5
Setup and Configuration
415