Deleting An Snmp User; Managing Snmp Security Model Mapping; Viewing A List Of Snmp Security Models - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Parameter
privacy-protocol { privacy-protocol }
privacy-key { privacy-key }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.11.7.3

Deleting an SNMP User

To delete an SNMP user, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the SNMP user by typing:
no admin snmp snmp-user id name
Where:
• id is the ID for the user
• name is the name of the user
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.11.8

Managing SNMP Security Model Mapping

The following sections describe how to configure and manage SNMP security models:
• Section 5.11.8.1, "Viewing a List of SNMP Security Models"
• Section 5.11.8.2, "Adding an SNMP Security Model"
• Section 5.11.8.3, "Deleting an SNMP Security Model"
Section 5.11.8.1

Viewing a List of SNMP Security Models

To view a list of SNMP security models configured on the device, type:
show running-config admin snmp snmp-security-to-group
If target addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin snmp snmp-security-to-group | tab
SECURITY USER
212
Description
A free-text password in the format <code>$0$&lt;your password&gt;</code>.
passphrase must be minimum 8 characters long
Synopsis: { none, des3cbc, aescfb128 }
Default: none
The symmetric privacy protocol providing data encryption and decryption for SNMP
exchanges between the user and the SNMP engine.
Synopsis: A string
A free-text password in the format <code>$0$&lt;your password&gt;</code>.
passphrase must be minimum 8 characters long
RUGGEDCOM ROX II
CLI User Guide
Deleting an SNMP User