Configuring Ntp Broadcast Clients; Enabling/Disabling The Ntp Service - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
address { address }
3. Add a multicast address for a known NTP server. For more information, refer to
Broadcast/Multicast
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.12.6

Configuring NTP Broadcast Clients

The NTP broadcast client enables the NTP server to receive advertisements from other NTP servers and send
advertisements of its own.
To configure the NTP broadcast client, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to services » time » ntp.
3. Configure the following parameters as required:
Parameter
broadcastclient
bind-interface { bind-interface }
4. Add a broadcast address for a known NTP server. For more information, refer to
a Broadcast/Multicast
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.12.7

Enabling/Disabling the NTP Service

To enable/disable the NTP service, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable the NTP service by typing:
services ntp enable
Disable the NTP service by typing:
no services ntp enable
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Configuring NTP Broadcast Clients
Address".
Address".
Description
Synopsis: A string
Default: 224.0.1.1
The multicast address on which the NTP client listens for NTP
messages.
Description
Synopsis: typeless
Enables/disables the broadcast client.
Sets the IP address for the selected interface as the source IP
address for outgoing NTP messages. Make sure an IP address
is first assigned to the selected interface. The dummy0 interface
should be used, unless required otherwise.
Chapter 5
Setup and Configuration
Section 5.12.12.2, "Adding a
Section 5.12.12.2, "Adding
219