Siemens RUGGEDCOM ROX II User Manual page 271

RUGGEDCOM ROX II
CLI User Guide
Parameter
apn-type { apn-type }
dial-string { dial-string }
sim { sim }
4. Configure the GSM PPP settings by typing the following commands:
Parameter
use-peer-dns
username { username }
password { password }
dial-on-demand
disconnect-idle-timeout { disconnect-idle-timeout }
failover-on-demand
mtu { mtu }
authentication { authentication }
Adding a GSM Profile
Description
The name of the wireless network access point.
Synopsis: { ipv4, ipv4v6 }
Default: ipv4
Specify APN type used to attach to PDN
Synopsis: A string
Default: *99***1#
The dial string given by the wireless provider to connect to the
access point name.
Synopsis: An integer between 1 and 2
Default: 1
Specify SIM index to be used by this profile
Description
Synopsis: typeless
Enables the DNS server entries that the PPP server
recommends. Enables this option unless you provide your own
name servers.
Synopsis: A string
Default: N/A
The user ID to connect to the remote server.
Synopsis: A string
Default: N/A
The password to be authenticated by the remote server.
Synopsis: typeless
Activates dial-on-demand for this connection. The establishment
of the PPP connection is postponed until there is data to be
transmitted via the interface. If dial-on-demand is configured,
Failover on Demand cannot be configured.
Prerequisite: If dial-on-demand is configured, Failover on
Demand cannot be configured.
Default: 0
The time in seconds to wait before disconnecting PPP when
there is no traffic on the link. This option is only valid when dial-
on-demand is enabled.
Synopsis: typeless
Activates link failover on-demand on this device. PPP link
establishment on this device is controlled by link failover. If
Failover on Demand is configured, Dial on Demand cannot be
configured.
Prerequisite: If link failover on-demand is configured, Dial on
Demand cannot be configured.
Synopsis: An integer between 128 and 1500
Default: 1500
MTU (Maximum Transmission Unit) value on a PPP interface.
Synopsis: { none, chap, pap }
Default: none
Chapter 5
Setup and Configuration
233