Deleting A Static Multicast Group; Managing Out-Interfaces - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
routing multicast static mcast-groups description
Where:
• description is the name of the multicast group. Up to 32 characters are allowed, excluding spaces.
3. Configure the following parameter(s) as required:
Parameter
source-ip { source-ip }
multicast-ip { multicast-ip }
in-interface { in-interface }
hw-accelerate
4. Configure out-interfaces. Refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.24.2.3

Deleting a Static Multicast Group

To delete a static multicast group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the multicast group by typing:
no routing multicast static mcast-groups description
Where:
• description is the name of the multicast group to be deleted
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.24.3

Managing Out-Interfaces

The following sections describe how to configure and manage out-interfaces:
• Section 5.24.3.1, "Viewing a List of Out-Interfaces"
Deleting a Static Multicast Group
Description
Synopsis: A string 7 to 15 characters long
The expected source IP address of the multicast packet, in the
format xxx.xxx.xxx.xxx. This address is uniquely paired with
the multicast address. You cannot use this IP address to create
another multicast routing entry with a different Multicast-IP
address.
Synopsis: A string 7 to 15 characters long
The multicast IP address to be forwarded, in the format
xxx.xxx.xxx.xxx The address must be in the range of 224.0.0.0 to
239.255.255.255. This address is uniquely paired with the source
IP address. You cannot use this IP address to create another
multicast routing entry with a different Source-IP address.
The interface upon which the multicast packet arrives.
Synopsis: typeless
If the multicast route can be hardware accelerated, the option will
be available. For a multicast route to be accelerated, the ingress
and egress interfaces must be switched.
Section 5.24.3.2, "Adding an Out-Interface"
Chapter 5
Setup and Configuration
411