RUGGEDCOM ROX II
CLI User Guide
!
If no in/out interfaces have been configured, add interfaces as needed. For more information, refer to
Section 3.24.7.2, "Adding In/Out
Section 3.24.7.2
Adding In/Out Interfaces
To add an in/out interface that can be used by a virtual switch filter, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the in/out interface by typing:
security virtualswitch-filter virtualswitch name rule rule [ in-interface | out-interface ]
interface
Where:
• name is the name of the virtual switch filter
• rule is the name of the rule
• interface is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.24.7.3
Deleting an In/Out Interface
To delete an in/out interface that can be used by a virtual switch filter, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the interface by typing:
no security virtualswitch-filter virtualswitch name rule rule [ in-interface | out-interface ]
interface
Where:
• name is the name of the virtual switch filter
• rule is the name of the rule
• interface is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.25
Managing a Domain Name System (DNS)
The following sections describe how to configure and manage a Domain Name Server (DNS):
•
Section 3.25.1, "Managing Domain Names"
•
Section 3.25.2, "Managing Domain Name Servers"
Adding In/Out Interfaces
Interfaces".
Chapter 3
Device Management
155