Adding An Ipv6 Static Route; Deleting A Static Route; Configuring A Black Hole Connection For An Ipv4 Static Route - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.23.3

Adding an IPv6 Static Route

To add an IPv6 static route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the IPv6 static route by typing:
routing ipv6 route subnet
Where:
• subnet is the subnet (network/prefix) of the static route
3. If necessary, configure either a gateway or an interface for the static route. Only one can be configured per
static route. For more information, refer to
Section 5.23.7.1, "Configuring Interfaces for IPv6 Static
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.23.4

Deleting a Static Route

To delete a static route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the static route by typing:
no routing protocol route subnet
Where:
• protocol is either IPv4 or IPv6
• subnet is the subnet (network/prefix) of the static route
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.23.5
Configuring a Black Hole Connection for an IPv4 Static
Route
To configure a black hole connection for an IPV4 static route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to routing » ipv4 » {subnet} » blackhole, where subnet is the subnet (network/prefix) of the static
route.
3. Configure the following parameter(s) as required:
Parameter
distance { distance }
Adding an IPv6 Static Route
Section 5.23.6.1, "Configuring Gateways for IPv6 Static Routes"
Routes".
Description
Synopsis: An integer between 1 and 255
Default: 1
Chapter 5
Setup and Configuration
or
405