Deleting A Zone; Managing Interfaces - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.17.8.3

Deleting a Zone

To delete a zone, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the zone by typing:
no security firewall fwconfig firewall fwzone name
Where:
• firewall is the name of the firewall
• name is the name of the zone
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.17.9

Managing Interfaces

Firewall interfaces are the LAN and WAN interfaces available to the router. Each interface must be placed in
a network zone. If an interface supports more than one zone, its zone must be marked as undefined and the
interface must use the zone host's setup to define a zone for each subnet on the interface.
Table: Example
Interface
Switch.0001
Switch.0002
Switch.0003
Switch.0004
W1ppp
The following sections describe how to configure and manage zones for a firewall:
• Section 5.17.9.1, "Viewing a List of Interfaces"
• Section 5.17.9.2, "Adding an Interface"
• Section 5.17.9.3, "Associating an Interface with a Zone"
• Section 5.17.9.4, "Configuring a Broadcast Address"
• Section 5.17.9.5, "Deleting an Interface"
Deleting a Zone
Description
Zone types are plain IPv4, firewall, or IPSec
Synopsis: A string
(Optional) The description string for this zone
Zone
Loc
Loc
Any
DMZ
net
Chapter 5
Setup and Configuration
277