RUGGEDCOM ROX II
CLI User Guide
•
Section 5.20.2, "Viewing the Status of Dynamic RIP Routes"
•
Section 5.20.3, "Managing Prefix Lists and Entries"
•
Section 5.20.4, "Managing Networks"
•
Section 5.20.5, "Managing Network IP Address"
•
Section 5.20.6, "Managing Network Interfaces"
•
Section 5.20.7, "Managing Neighbors"
•
Section 5.20.8, "Managing the Prefix List Distribution"
•
Section 5.20.9, "Managing Key Chains and Keys"
•
Section 5.20.10, "Managing Redistribution Metrics"
•
Section 5.20.11, "Managing Routing Interfaces"
Section 5.20.1
Configuring RIP
To configure dynamic routing using the Routing Information Protocol (RIP) daemon, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to routing » rip and configure the following parameter(s) as required:
Parameter
enabled
default-information-originate
default-metric { default-metric }
distance-default { distance-default }
version { version }
update { update }
timeout { timeout }
garbage { garbage }
Configuring RIP
Description
Synopsis: typeless
Enables the RIP dynamic routing protocol.
Synopsis: typeless
The route element makes a static route only inside RIP. This element should be used
only by advanced users who are particularly knowledgeable about the RIP protocol. In
most cases, we recommend creating a static route and redistributing it in RIP using the
redistribute element with static type.
Synopsis: An integer between 1 and 16
Default: 1
Sets the default metric. With the exception of connected route types, the default metric
is advertised when a metric has not been configured for a redistributed route. For
connected route types, the default metric is 1 despite the value of this parameter.
Synopsis: An integer between 1 and 255
Sets the default RIP distance.
Synopsis: An integer between 1 and 2
Set the RIP version to accept for reads and send. The version can be either 1 or 2.
Disabling RIPv1 by specifying version 2 is STRONGLY encouraged.
Synopsis: An integer between 5 and 2147483647
Default: 30
The routing table update timer (in seconds).
Synopsis: An integer between 5 and 2147483647
Default: 180
The routing information timeout timer (in seconds).
Synopsis: An integer between 5 and 2147483647
Default: 120
Chapter 5
Setup and Configuration
339