Viewing A List Of Hdlc-Eth Vlans; Adding An Hdlc-Eth Vlan - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
• Section 5.37.6.2, "Adding an HDLC-ETH VLAN"
• Section 5.37.6.3, "Deleting an HDLC-ETH VLAN"
Section 5.37.6.1

Viewing a List of HDLC-ETH VLANs

To view a list of VLANs configured for an HDLC-ETH connection, type:
show running-config interface wan interface protocol channel connection hdlc-eth vlan id
Where:
• interface is the WAN interface
• protocol is either T1 or E1
• id is the ID of the VLAN
If VLANs have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface wan lm4 1 t1 channel connection hdlc-eth vlan | tab
CHANNELNUMBER VID
---------------------------------------------------------------
1
100
200
!
!
If no VLANs have been configured, add VLANs as needed. For more information, refer to
"Adding an HDLC-ETH
Section 5.37.6.2

Adding an HDLC-ETH VLAN

To add a VLAN to an HDLC-ETH connection, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the VLAN by typing:
interface wan interface protocol channel number connection hdlc-eth vlan id
Where:
• interface is the WAN interface
• protocol is either T1 or E1
• number is the channel number
• id is the ID of the VLAN
3. Configure the following parameter(s) as required:
Parameter
on-demand
554
IP
ON ADDRESS
DEMAND MTU SRC
- 1500 static
- 1500 static
VLAN".
QOS INGRESS MARK
Description
Synopsis: typeless
RUGGEDCOM ROX II
CLI User Guide
Section 5.37.6.2,
Viewing a List of HDLC-ETH VLANs