Table of Contents
Advertisement
Chapter 5
Setup and Configuration
Parameter
destination-ports { destination-ports }
original-destination { original-destination }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.17.14.3
Configuring the Source Zone
To configure the source zone for a firewall rule, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to security » firewall » fwconfig » {firewall} » fwrule{rule} » source-zone, where {firewall} is the
name of the firewall and {rule} is the name of the rule.
3.
Configure the following parameter(s) as required:
Parameter
predefined-zone { predefined-zone }
other { other }
all
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.17.14.4
Configuring the Destination Zone
To configure the destination zone for a firewall rule, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Configure the following parameter(s) as required:
292
Description
(Optional) The TCP/UDP port(s) the connection originated from.
Default: all ports. Add a single port or a list of comma-separated
ports
Synopsis: A string
Default: none
(Optional) The TCP/UDP port(s) the connection is destined for.
Default: all ports. Add a single port or a list of comma-separated
ports
Synopsis: { None } or a string
Default: none
(Optional) The destination IP address in the connection request
as it was received by the firewall.
Synopsis: A string
(Optional) The description string for this rule.
Description
A predefined zone
Synopsis: A string
Type a custom definition - this can be a comma-separated list of
zones.
All zones
RUGGEDCOM ROX II
CLI User Guide
Configuring the Source Zone
Advertisement
Table of Contents
Troubleshooting
