Configuring Interfaces For Ipv6 Static Routes; Viewing A List Of Interfaces For Ipv4 Static Routes; Adding An Interface For An Ipv4 Static Route - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
• Section 5.23.7.1, "Configuring Interfaces for IPv6 Static Routes"
• Section 5.23.7.2, "Viewing a List of Interfaces for IPv4 Static Routes"
• Section 5.23.7.3, "Adding an Interface for an IPv4 Static Route"
• Section 5.23.7.4, "Deleting an Interface for an IPv4 Static Route"
Section 5.23.7.1

Configuring Interfaces for IPv6 Static Routes

To configure an interface for an IPv6 static route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to routing » ipv6 » route » {subnet} » dev, where subnet is the subnet (network/prefix) of the
static route.
3. Configure the following parameter(s) as required:
Parameter
interface { interface }
distance { distance }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.23.7.2

Viewing a List of Interfaces for IPv4 Static Routes

To view a list of interfaces assigned to an IPv4 static route, type:
show running-config routing ipv4 route subnet dev
Where:
• subnet is the subnet (network/prefix) of the static route
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ipv4 route 0.0.0.0/0 dev
routing ipv4 route 0.0.0.0/0
dev switch.0001
no distance
!
!
If no interfaces have been configured, add interfaces as needed. For more information, refer to
"Adding an Interface for an IPv4 Static
Section 5.23.7.3

Adding an Interface for an IPv4 Static Route

To add an interface for an IPv4 static route, do the following:
408
Description
The interface for the static route.
Synopsis: An integer between 1 and 255
The distance for the static route.
Route".
Section 5.23.7.3,
Configuring Interfaces for IPv6 Static Routes
RUGGEDCOM ROX II
CLI User Guide