Chapter 5
Setup and Configuration
Section 5.20.3.5
Deleting a Prefix List
To delete a prefix list for dynamic RIP routes, do the following:
1.
Make sure the CLI is in Configuration mode.
NOTE
Deleting a prefix list removes all associate prefix entries as well.
2.
Delete the list by typing:
no routing rip filter prefix-list name
Where:
• name is the name of the prefix list
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.20.3.6
Deleting a Prefix Entry
To delete an entry for a dynamic RIP prefix list, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the entry by typing:
no routing rip filter prefix-list name entry number
Where:
• name is the name of the prefix list
• number is the sequence number for the entry
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.20.4
Managing Networks
As opposed to neighbors, which are specific routers with which to exchange routes, networks are groups of
routers that are either part of a specific subnet or connected to a specific network interface. They can be used at
the same time as neighbors.
NOTE
For point to point links, such as T1/E1 links, specify neighbors instead of a network. For more
information, refer to
NOTE
RIP v1 does not send subnet mask information in its updates. Any networks defined are restricted to
the classic (i.e. Class A, B and C) networks.
344
Section 5.20.7.2, "Adding a
Neighbor".
RUGGEDCOM ROX II
CLI User Guide
Deleting a Prefix List