Managing Pre-Shared Keys; Viewing A List Of Pre-Shared Keys; Adding A Pre-Shared Key - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Section 5.29.5

Managing Pre-Shared Keys

Pre-shared keys are used in secret key cryptography. For more information about secret key cryptography and
pre-shared keys, refer to
The following sections describe how to configure and manage pre-shared keys for IPsec tunnels:
• Section 5.29.5.1, "Viewing a List of Pre-Shared Keys"
• Section 5.29.5.2, "Adding a Pre-Shared Key"
• Section 5.29.5.3, "Deleting a Pre-Shared Key"
Section 5.29.5.1

Viewing a List of Pre-Shared Keys

To view a list of pre-shared keys, type:
show running-config tunnel ipsec preshared-key
If pre-shared keys have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config tunnel ipsec preshared-key
tunnel
ipsec
preshared-key 192.168.12.1 192.168.12.2
key $4$9YslfOBfkyYV8c1tqN4IDw==
!
!
!
If no pre-shared keys have been configured, add pre-shared keys as needed. For more information, refer to
Section 5.29.5.2, "Adding a Pre-Shared
Section 5.29.5.2

Adding a Pre-Shared Key

To add a pre-shared key, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the pre-shared key by typing:
tunnel ipsec preshared-key [ remote-address | local-address ] key key
Where:
• remote-address is the remote IP address
• local-address is the local IP address
• key is the is the content of the pre-shared key
3. Configure the following parameter(s) as required:
Parameter
key { key }
462
Section 5.29.1.3, "Public and Secret Key
Key".
Cryptography".
Description
Synopsis: A string
RUGGEDCOM ROX II
CLI User Guide
Managing Pre-Shared Keys