Viewing The Status Of 6In4/4In6 Tunnels; Adding A 6In4 Or 4In6 Tunnel; Deleting A 6In4 Or 4In6 Tunnel - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.30.3

Viewing the Status of 6in4/4in6 Tunnels

To view the status of a 6in4 or 4in6 tunnel, type:
show interfaces [ ip6in4 | ip4in6 ] tunnel name
Where:
• name is the name of the tunnel
A table or list similar to the following example appears:
ruggedcom# show interfaces ip6in4 tunnel
TUNNEL
NAME LOCAL IP
----------------------------------------------
tu 192.168.20.10
Section 5.30.4

Adding a 6in4 or 4in6 Tunnel

To add a 6in4 or 4in6 tunnel, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the tunnel by typing:
tunnel [ ip6in4 | ip4in6 ] tunnel name
Where:
• name is the name of the tunnel
3. Configure the following parameter(s) as required:
Parameter
local-ip
remote-ip
status
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.30.5

Deleting a 6in4 or 4in6 Tunnel

To delete a 6in4 or 4in6 tunnel, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the tunnel by typing:
Viewing the Status of 6in4/4in6 Tunnels
REMOTE IP STATUS
192.168.20.20 Active
Description
Synopsis: A string 7 to 15 characters long
The interface upon which the tunnel is created
Synopsis: A string 7 to 15 characters long
Ip address of remote tunnel end
Synopsis: A string
Current status of tunnel
Chapter 5
Setup and Configuration
475