Viewing A List Of Cdma Profiles; Adding A Cdma Profile - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
The following sections describe how to configure and manage CDMA profiles:
• Section 5.13.1.1, "Viewing a List of CDMA Profiles"
• Section 5.13.1.2, "Adding a CDMA Profile"
• Section 5.13.1.3, "Deleting a CDMA Profile"
Section 5.13.1.1

Viewing a List of CDMA Profiles

To view a list of CDMA profiles, type:
show running-config global cellular profiles cdma
If profiles have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config global cellular profiles cdma | tab
DIAL
NAME STRING
--------------------------------------------------------------------------------
gsm-cdma #777
!
If no CDMA profiles have been configured, add profiles as needed. For more information, refer to
Section 5.13.1.2, "Adding a CDMA
Section 5.13.1.2

Adding a CDMA Profile

To add a CDMA profile for the cellular modem interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the restriction by typing:
global cellular profiles cdma name
Where:
• name is the name of the profile
3. Configure the cellular network by typing the following commands:
Parameter
dial-string { dial-string }
4. Configure the CDMA PPP settings by typing the following commands:
Parameter
use-peer-dns
230
USE
PEER
DNS USERNAME PASSWORD
- N/A N/A
Profile".
DIAL DISCONNECT FAILOVER
ON IDLE ON
DEMAND TIMEOUT DEMAND
- 0 -
Description
Synopsis: A string 1 to 32 characters long
Default: #777
The dial string to connect to the wireless provider.
Description
Synopsis: typeless
RUGGEDCOM ROX II
CLI User Guide
MTU
1500
Viewing a List of CDMA Profiles