Viewing A List Of Virtual Switch Vlans; Adding A Virtual Switch Vlan; Deleting A Virtual Switch Vlan - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Section 5.37.7.1

Viewing a List of Virtual Switch VLANs

To view a list of virtual switch VLANs, type:
show running-config interface virtualswitch id vlan
Where:
• id is the ID assigned to the virtual switch
If VLANs have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface virtualswitch 1 vlan | tab
IP
ADDRESS
VID SRC QOS
----------------------------------
100 static
!
!
If no virtual switch VLANs have been configured, add VLANs as needed. For more information, refer to
Section 5.37.7.2, "Adding a Virtual Switch
Section 5.37.7.2

Adding a Virtual Switch VLAN

To add virtual switch VLAN, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the virtual switch by typing:
interface virtualswitch id vlan vlan-id
Where:
• id is the ID assigned to the virtual switch
• vlan-id is the ID assigned to the VLAN
3. Configure the following parameter(s) as required:
Parameter
ip-address-src { ip-address-src }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.37.7.3

Deleting a Virtual Switch VLAN

To delete a virtual switch VLAN, do the following:
556
INGRESS MARK
VLAN".
Description
Synopsis: { static, dynamic }
Default: static
Whether the IP address is static or dynamically assigned via
DHCP or BOOTP.
Viewing a List of Virtual Switch VLANs
RUGGEDCOM ROX II
CLI User Guide