Viewing The Status Of Pim-Sm - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
2. Add the RP candidate by typing:
routing multicast dynamic pim-sm RP-candidate local-address timer priority number
Where:
• local-address is the local address to be used in the Cand-RP messages. If not specified, the largest
local IP address will be used (excluding passive interfaces).
• timer is the number of seconds to wait between advertising and Cand-RP message.
• priority sets the priority for this CRP. Smaller value means higher priority.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.25.7

Viewing the Status of PIM-SM

To view the status of PIM-SM, do the following:
1. Make sure the CLI is in Configuration mode.
At the command prompt, type show routing status pim-sm and press Enter. The PIM-SM routing
2.
status information appears:
ruggedcom# show routing status pim-sm
routing status pim-sm
bsr 1.1.1.1
vinterface
LOCAL
INDEX ADDRESS
---------------------------------------------------------------
0 192.168.0.12
1 169.254.72.4
2 1.1.1.1
3 169.254.0.1
4 192.168.11.1
5 192.168.12.1
6 192.168.14.1
rp
ID PREFIX
--------------------------------------------
3.3.3.3
225.0.0.1/32
225.0.0.2/32
Parameter
local-address
subnet
flags
418
SUBNET FLAGS
192.168.0.0/24 DISABLED
169.254.72.0/28 DISABLED
1.1.1.1/32 DR NO-NBR
169.254.0.0/24 DISABLED
192.168.11.0/24 DR NO-NBR
192.168.12.0/24 PIM
192.168.14.0/24 PIM
PRIORITY HOLDTIME
1 105
1 105
ID
192.168.12.2
192.168.14.4
Description
Synopsis: A string 1 to 16 characters long
Local address.
Synopsis: A string 1 to 20 characters long
Subnet.
Synopsis: A string 1 to 128 characters long
Flags indicates virtual interface information.
<itemizedlist><listitem>DISABLED: The virtual interface is
administratively disabled for PIM-SM.</listitem> <listitem>DOWN:
This virtual interface is down.</listitem> <listitem>DR: Designated
RUGGEDCOM ROX II
CLI User Guide
Viewing the Status of PIM-SM