Viewing A List Of Ldp Interfaces; Enabling/Disabling An Ldp Interface - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Parameter
Section 5.41.7.8

Viewing a List of LDP Interfaces

To view a list of LDP interfaces, type:
show running-config mpls ldp interface-ldp
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config mpls ldp interface-ldp | tab
TRANSPORT
IFNAME ENABLED
------------------------------------
fe-cm-1 false
switch.0001 false
switch.0010 true
switch.0020 false
!
!
For more information about enabling LDP interfaces, refer to
Interface".
Section 5.41.7.9

Enabling/Disabling an LDP Interface

To enable or disable an LDP interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable/disable the LDP interface by typing the following commands:
Enable
mpls ldp interface-ldp name
Disable
no mpls ldp interface-ldp name
Where:
• name is the name of the transport interface to be enabled or disabled.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
612
TRANSPORT IP
ADDRESS
-
-
192.168.10.1
-
Description
The time (in seconds) that a discovered LDP neighbor is
remembered without receipt of an LDP Hello message from the
neighbor.
Section 5.41.7.9, "Enabling/Disabling an LDP
RUGGEDCOM ROX II
CLI User Guide
Viewing a List of LDP Interfaces