Chapter 3
Device Management
Parameter
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
7.
Section 3.21.3
Deleting an Ethernet Trunk Interface
To delete an Ethernet trunk interface, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the interface by typing:
no interface trunks id
Where:
• id is the ID given to the trunk
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.21.4
Managing Ethernet Trunk Ports
The following sections describe how to configure and manage Ethernet trunk ports:
•
Section 3.21.4.1, "Viewing a List of Ethernet Trunk Ports"
•
Section 3.21.4.2, "Adding an Ethernet Trunk Port"
•
Section 3.21.4.3, "Deleting an Ethernet Trunk Port"
Section 3.21.4.1
Viewing a List of Ethernet Trunk Ports
To view a list of Ethernet trunk interfaces, type:
show running-config interface trunks id trunk-ports
Where:
• id is the ID given to the interface
If trunk ports have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface trunks 1 trunk-ports
interface
trunks 1
trunk-ports lm1 1
!
trunk-ports lm1 2
!
!
!
124
Description
VLANs existing in the switch (configured or learned) and can
dynamically learn VLANs.</listitem></itemizedlist>
Deleting an Ethernet Trunk Interface
RUGGEDCOM ROX II
CLI User Guide