Viewing A List Of Vrrp Instances; Adding A Vrrp Instance - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.27.6.1

Viewing a List of VRRP Instances

To view a list of VRRP instances, type:
show running-config services vrrp instance
If instances have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services vrrp instance
services
vrrp
instance vid20
interface switch.0001
vrid 10
priority 100
group group1
monitor fe-cm-1
!
track-script tracker1
!
vrip 192.168.0.10/24
!
!
!
!
If no VRRP instances have been configured, add instances as needed. For more information, refer to
Section 5.27.6.2, "Adding a VRRP
Section 5.27.6.2

Adding a VRRP Instance

To add a VRRP instance, do the following:
1. Make sure the CLI is in Configuration mode.
2. Make sure a VRRP group has been configured. For more information, refer to
VRRP Group".
3. Add the instance by typing:
services vrrp instance name
Where:
• name is the name of the VRRP instance. The name must not include spaces.
4. Configure the following parameter(s) as required:
NOTE
A preemption occurs when either:
• a backup VRRP router gains higher priority and transitions to the Master state
• VRRP is initiated and this router has higher priority than that of any VRRP router on the network
Parameter
vrrp-version { vrrp-version }
Viewing a List of VRRP Instances
Instance".
Section 5.27.5.2, "Adding a
Description
Synopsis: An integer between 2 and 3
Default: 2
Chapter 5
Setup and Configuration
441